This product may not attach to all crib designs. Do not add additional strings or straps to attach to a crib or playpen. In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury or ruin your product. To avoid battery leakage: Do not mix old and new batteries or batteries of different types: alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium). Insert batteries as indicated inside the battery compartment. Remove batteries during long periods of non-use. Always remove exhausted batteries from the product. Dispose of batteries safely. Do not dispose of this product in a fire. The batteries inside may explode or leak. Never short-circuit the battery terminals. Use only batteries of the same or equivalent type, as recommended. Do not charge non-rechargeable batteries. Remove rechargeable batteries from the product before charging. If removable, rechargeable batteries are used, they are only to be charged under adult supervision. This toy has no consumer serviceable parts. Do not take apart. Wipe this toy with a clean, damp cloth. The mat is surface washable only. Do not immerse.
Fit the clips onto the back of the activity center and tighten the screws in each clip. Do not over-tighten. Hint: The clips are designed to fit on the activity center one way. If the clips do not seem to fit, turn them around and try again. Fit the "T" straps on the mat through the slots in the toys. Make sure the end of each strap forms a "T" through the slot. Slide the clips onto the play yard wall. Push down to be sure it is completely attached. Always attach all provided fasteners (strings, straps, clamps, etc.) tightly to a crib or playpen according to the instructions. Check frequently. Slide the power/volume switch to ON with low volume or ON with high volume. Pull the penguin for sounds! When you are finished playing with this toy, slide the power/volume switch OFF. Battery Replacement: For best performance, we recommend replacing the battery that came with this toy with a new "AA" (LR6) alkaline battery. Locate the battery compartment door on the back of the this toy. Loosen the screws in the door and remove it. Remove the exhausted battery and dispose of it properly. Insert a new "AA" (LR6) alkaline battery. Replace the battery compartment door and tighten the screws. Do not over-tighten. If this toy begins to operate erratically, you may need to reset the electronics. Slide the power/volume switch off and then back on. When sounds from this toy become faint or stop, it’s time for an adult to change the battery.
