Fasten your own hair into a ponytail. How high you place it will determine the final look of the style.
With the inside of the hairpiece facing away from you, insert the three-pronged comb into your hair directly underneath the rubber band.
Once the three-pronged comb is firmly in place, grasp the top strip with both hands and hold it horizontally.
Wrap the left side of the strip underneath your ponytail.
Next, wrap the right side of the strip underneath your ponytail. Place the right end of the self-grip strip firmly against the left end to connect.
Once the self-grip connection is firmly in place, wrap the long strip of hair around the top of your ponytail and secure with a hairpin.
Finish the style as you wish.
Cleansing the wrapped ponytail:
Remove tangles gently with fingers or a pick. Don't brush.
Mix a dime size amount of a gentle shampoo into a basin of cool water.
Immerse ponytail for 5 minutes.
Rinse thoroughly in clear, cool water. Do not rub.
Make sure all shampoo is rinsed out, as residue could cause damage to fibers.
Blot gently with a clean, dry towel to remove excess water. Don't twist or squeeze.
Brushing or combing wet ponytail is not recommended as fibers could stretch or break.
To dry, simply hang up or use your blow dryer on the lowest setting heat & curl faux hair can withstand heat levels up to 180°C/350°F.
Do not style, straighten or curl heat & curl faux hair while wearing it.
Thermal styling tools may also be used on heat settings up to 180°C/350°F. The fiber may scorch on a higher setting.
For best results when straightening the heat & curl faux hair, take a one-inch section and run a flat iron over the hair from root to ends. Repeat until all the hair is straightened to your satisfaction.
When curling heat & curl faux hair with a curling iron, create the curl by wrapping a section of hair around the barrel, hold for 10-20 seconds, and then carefully slide it off the iron. Hold the warm curl in place, pin it with a clip and wait until it cools. Once the curl is cool and set, remove the clip and style as desired.