These sterile drops are for rigid gas permeable contact lenses
Contains no polyquad, chlorhexidine, polyaminopropyl biguanide, or BAK
Not tested on animals
Warnings
Contains sodium bisulfite, a sulfite that may cause serious allergic reactions (e.g. hives, itching, wheezing, anaphylaxis) in certain susceptible persons. Although the overall incidence of sulfite sensitivity in the general population is low, it is seen more frequently in asthmatics or in atopic non-asthmatic persons. If you are allergic to sodium bisulfite or any other ingredient in Optimum WRW, do not use this product.
Close cap after each use.
To avoid contamination, do not touch dropper tip to any surface.
Please note carefully the ingredients as listed. If you are allergic to sodium bisulfite or any other ingredient in Optimum Sterile Wetting and Rewetting Drop, do not use this product. Precautions:
Always was and rinse hands before handling your lenses
After inserting your lenses, always empty your lens storage case, rinse, and allow to air dry.
Store at room temperature 15-30°C (59-86°F)
Keep out of reach of children.
Optimum Sterile Wetting and Rewetting Drop is NOT for use with soft (hydrophilic) contact lenses.
To protect against loss, always be sure sink drain is closed prior to rinsing lenses.
Comments about Lobob Optimum Wetting and Rewetting Drops, 1 Ounces:
My favorite of all those I've tried over 55 years of wearing contact lenses. The wetting solution is effective, feels comforting and only a couple of quick blinks to see perfectly.
Optimum WRW wets lenses prior to insertion. Also use directly in eye during the wearing cycle to relieve occasional dryness and discomfort. For use:
Always wash and rinse your hands before handling your contact lenses
Clean and rinse the right lens first (always the same lens to avoid mix-ups)
Wetting:
Remove the right lens from the lens storage case and rinse thoroughly as directed by your eye care practitioner (All disinfecting and storage solution must be rinsed from the lens before wetting with Optimum WRW and inserting the lens)
Apply 2 drops of Optimum WRW over all surface of the lens without rubbing the lens
Insert the lens as instructed by your eye care practitioner
Repeat the procedure with the left lens
Lubricating:
When your lenses feel dry, apply no more than two (2) drops of Optimum WRW directly in the eye
Description:
For Rigid Gas Permeable Contact Lenses (Fluorosilicone Acrylate and Silicone
Acrylate) and Hard Contact Lenses Wetting and Rewetting Drops "Recommended especially for RGP lenses made in Menicon Z material" Sterile ...
Description:
Helps Keep Lenses Clean while You Wear Them For soft
and RGP contact lenses Helps remove protein and prevent buildup during lens wear Over the course of the day, a ...
Description:
Advance Formula Removes Deposits Visibly Tinted for Improved Rinsing For
Rigid Gas Permeable Contact Lenses This unique patented formula is not sold to any retailer as a store brand. ADVANCE FORMULA ...
