For Rigid Gas Permeable Contact Lenses
(Fluorosilicone Acrylate and Silicone Acrylate) and Hard Contact Lenses

Wetting and Rewetting Drops

"Recommended especially for RGP lenses made in Menicon Z material"

• Sterile
• Contains no Polyquad, Chlorhexidine, Polyaminopropyl Biguanide, or BAK

MeniCare GP WRW wets lenses prior to insertion. Also use directly in the eye during the wearing cycle to relieve occasional dryness and discomfort.

Comments or Questions? 1-800-MENICON

Contains sodium bisulfite, a sulfite that may cause serious allergic reactions (e.g. hives, itching, wheezing, anaphylaxis) in certain susceptible persons. Although the overall incidence of sulfite sensitivity in the general population is low, it is seen more frequently in asthmatics or in atopic non-asthmatic persons. If you are allergic to sodium bisulfite or any other ingredient in MeniCare GP WRW, do not use this product.

Close cap after each use. To avoid any contamination, do not touch dropper tip to any surface.

Please note carefully the ingredients as listed. If you are allergic to sodium bisulfite or any other ingredient in MeniCare GP Sterile Wetting and Rewetting Drop, do not use this product.

Always wash and rinse hands before handling your lenses.

After inserting your lenses, always empty your lens storage case, rinse, and allow to air dry. Keep out of reach of children. Use before expiration date stamped on carton and bottle label. MeniCare GP Sterile Wetting and Rewetting Drop is not for use with soft (hydrophilic) contact lenses. To protect against loss, always be sure sink drain is closed prior to rinsing lenses. Discard 60 days after opening.

General Instructions:

• Always wash and rinse your hands before handling your contact lenses.
• To avoid lens mixup, always clean your right lens first and your left lens last.

Wetting:

• Remove the right lens from the lens storage case and rinse thoroughly as directed by your eye care professional. (All disinfecting and storage solution must be rinsed from the lens before wetting with MeniCare GP WRW and inserting the lens.)
• Apply two drops of MeniCare GP WRW over all surfaces of the lens without rubbing the lens.
• Insert the lens as instructed by your eye care professional.
• Repeat the procedure with the left lens.

Lubricating:

• When your lenses feel dry, apply no more than two (2) drops of MeniCare GP WRW directly in the eye.