Command Strips Damage Free Hanging: Picture, Frame & Poster Hanging Strips, Medium 3 set

Picture & Frame Hanging

3M™ Medium Picture Hanging Strips with Command™ Adhesive hold firmly where placed.  Fasteners can be separated and reattached.  When removed, they come off cleanly without surface damage. Each set holds up to 3 pounds with 3 sets per pack.

Holds Strongly.  Removes Cleanly

Three sets of Medium Strips

Holds most frames up to 45.7cm x 60.9cm/18 x 24 in

Caution: Do not use with delicate or paper wallpaper. May not adhere well to some vinyl wallpapers. Do not use for antiques, heirlooms, or other valuable or irreplaceable items.Do not hang objects over beds.

Apply to surfaces above 15°F (-10°C). Adhesive could soften and lose adhesion above 125°F (50°C). Do not use as a grab bar.

Important: Follow instructions carefully! Save instructions for clean removal in the future!

To Apply:

1. Select Location - Choose a location where strips are not over grout lines if possible. Caution: Place hook in accessible position for removal by ensuring tabs can stretch at least 15 inches upon removal.
2. Clean & Dry Surface - Thoroughly clean surface with isopropyl rubbing alcohol to remove all soap, shampoo and cleaner residue. Wipe surface completely dry. Do not use household cleaners.
3. Apply Strips - Two strips will go on mounting base. Separate strips. Remove red Command™ Strips liners. Align square end of strip with solid line on top of mounting base, placing one strip on each side of dotted lines. Press firmly. Repeat with other strip. Remove black "wall side" liner. Make sure round tabs are at bottom of mounting base.
4. Position & Press - Position and press entire hook firmly against surface for 5 second.
5. Remove Hook - Slide hook up to remove from mounting.
6. Press Firmly! - Firmly press mounting base along length of each strip for at least 30 seconds.
7. Wait 1 hour to allow adhesive bond.
8. Slide Hook back onto mounting base until it snaps into place.

To Remove:

1. Slide Hook Off Base - Reveal mounting base and removal tabs.
2. Hold Base Lightly - To prevent base from snapping your fingers, lightly hold mounting base as shown.
3. Remove Strip - Never pull strip out at an angle. Strip could break or damage surface. Slowly slide tab straight down against wall stretching strip at least 15 inches (40 cm) until mounting base releases from wall. Remove one strip at a time. Repeat with additional strip.