To install: 1. Thoroughly clean & dry all surfaces. 2. With the angle lock assembled, position lock in desired position. Mark with pencil. 3. While assembled, peel off backing tape & press firmly into position. 4. As with most adhesive products, stronger adhesion is achieved by allowing adhesive to set for several hours. If possible, allow 24 hours for maximum adhesion. To use: Push outward on the side release while opening the drawer, etc. Locks automatically when drawer, etc. is closed. To remove product: Use rubber cement solvent, eucalyptus oil, or similar type of product. Keep remover out of the reach of children. To relocate product: Replace adhesive tape with strong double sided tape. |