This product meets AOAC Germicidal Spray Product Test standards for hospital aerosol disinfectants.
This can is made from an average 25% recycled steel (10% post-consumer). Encourage your local authorities to establish a program to recycle this can.
Contains no CFCs or other ozone depleting substances. Federal regulations prohibit CFC propellants in aerosols.
1-800-228-4722
Made in USA
**Kills Staphylococcus Aureus, Avian Influenza A Virus, Escherichia Coli O157:H7 and Respiratory Syncytial Virus on hard, on-porous surfaces in 10 minutes.
***Kills Staphylococcus Aureus on hard, non-porous, non-food contact and soft surfaces in 30 seconds.
Warnings
Keep out of reach of children. Do not use on silk, rayon acetate or satin fabrics. Hazards to Humans and Domestic Animals: Causes moderate eye irritation. Do not spray eyes, on skin or on clothing. Wash thoroughly with soap and water after handling and before eating, drinking, chewing gum, using tobacco or using the toilet. If In Eyes: Hold eye open and rinse slowly and gently with water for 15-20 minutes; remove contact lenses, if present, after the first 5 minutes, then continue rinsing eye; call a Poison Control Center or doctor for treatment advice. Flammable: contents under pressure. Keep away from heat,, sparks and open flame. Do not puncture or incinerate container. Exposure to temperatures above 130°F may cause bursting. Do not reuse empty container.
Comments about Lysol Disinfectant Spray, Lemon Breeze, 19 oz:
The lemon smell of this product is fresh and clean without being cloying. As with all lysol products, it kills the germs. My favorite fragrance that lysol offers
Pre-clean surfaces prior to use. Hold can upright 6" o 8" from surface. Spray 2 to 3 seconds until covered with mist. To Deodorize: Spray on surfaces as needed. To Sanitize: Let stand for 30 seconds then allow to air dry. To Disinfect: Let stand for 10 minutes then allow to air dry. Rinse toys and food contact surfaces with potable water after use. Fabric SanitizeR: For spot treatment (2" x 2" area" only. To Spot Sanitize Soft Surfaces: Spray until fabric is wet. Do not saturate. Fabric must remain wet for 30 seconds. Let air dry. For difficult odors, repeat application. To Control and Prevent Mold & Mildew: Apply to pre-cleaned surface. Allow to remain wet for 3 minutes. Let air dry. Repeat applications in weekly intervals or when mold and mildew growth appears. Do not use on polished wood, painted surfaces, leather, rayon fabrics, or acrylic plastics. Always test on a hidden area of fabric. Store in original container in areas inaccessible to small children. Discard in trash or offer for recycling if available.