Glade Sense & Spray Starter, Clean Linen 0.43 oz (12.2 g)

Adjustable Glade® Sense & Spray® Starter

• Motion Activated with 4 Sensors
• Uses the Same Refills as Previous Sense & Spray Starters

Glade Sense & Spray Starter (Round) features a new adjustable lockout switch, which controls the length of time the unit will not spray after motion activation and gives the consumer more control.  The new starter uses the same Sense & Spray refills as the other Sense & Spray Starters.  The new starter is motion activated and has 4 sensors that allow for placement anywhere within a room.

Requires 2-AA Batteries (Included)

Includes:

• 1 - Spray Unit
• 1 - Refill
• 2 - AA Batteries

Ingredients:
Clean Linen Spray Refill:  Solubilizer, Propellant, Fragrance.

Caution:  Contents under pressure.  Do not expose to heat or store above 120°F.  Do not puncture or incinerate.  Do not place unit below any electrical outlet and / or light switches.  Do not use in asthma or medical inhalers.  Do not use in small, confined pet areas.  Keep out of reach of children and pets.  Keep the unit pointed away from you and others during assembly.  It automatically sprays a burst of fragrance 5 seconds after assembly to show it is working properly.

Usage instructions:  The smart unit automatically sprays fragrance when a shadow has been cast upon the sensor.  The unit is in active mode and ready to detect motion when the light blinks every 5 seconds.  After the unit has sprayed, in order to conserve the refill, the sensor will turn off automatically and will not spray for 20 minutes.  For an instant burst of Glade fragrance anytime, press the boost button in the front of the unit.  Use only Glade Sense & Spray refills in this unit.  Placement instructions:  For best results, place unit upright on a flat surface where upward spray will not be obstructed.  Place unit within 5 feet of traffic flow.  Helpful hints:  The sensor may not respond if:  The room is too dark.  Ensure there's sufficient lighting to allow a shadow to be cast upon sensor.  The unit is placed directly on or in a light source, especially sunlight.  Move the unit out of the bright light.  Sensor on the front of the device is blocked by objects.  Position the unit so that the sensor is unobstructed.  Assembly instructions:  Lift front cover.  Lay canister into position over the tan tab.  Snap canister into place.  You will hear a click to know the refill has been inserted correctly.  Pull and discard red tab to activate batteries.  Replacing canister:  Lift front cover and remove the empty canister.  To install new canister, follow assembly instructions in steps 2 – 3.  Replacing batteries:  Lift front cover.  Insert 2 new AA batteries.  Note:  Be sure that replacement batteries are positioned correctly.  Unit will not function if batteries are installed backward.  Store in a cool, dry place.