Quick Setting Epoxy automatically dispenses into equal parts with one push. Perfect for bonding glass, metal, china, wood, fiberglass or any project requiring 5 minute set time for parts. No mess, no spilling and no dried out tubes. Position time 2-3 minutes.
Find the Right Glue. Fast.
Other Epoxies Made by Super Glue Corporation
Extra Setting Time
Made in USA
Caution: Irritation to eyes and skin. May cause sensitization by skin contact. Contains epoxy resin and polymercaptan hardener. In case of skin contact, wash thoroughly with soap and water. In case of contact with eyes, flush with water for 15 minutes. Call a physician. If swallowed seek medical advice immediately and show the container label. Use in well ventilated area. Keep out of reach of children.
Protect work surface (metal foil works well). Bonding surface should be clean and dry. Roughen smooth surface for better adhesion (using abrasives or sandpaper). Remove storage cap located in plunger. Point tip away from face and body while opening.Point syringe towards mixing tray and snap off tip end to open. Use plastic blister or clean cardboard to mix on. Do not mix on metal. Dispense equal parts of resin and hardener by pressing down slowly on plunger. Mix thoroughly until uniform color using a wooden stick, plastic knife or other clean non-metal stirrer. Apply mixing epoxy to both surfaces to be bonded and hold parts together with a clamp, tape or weights. Remove excess epoxy immediately using a paper towel and denatured alcohol, prior to set. Product sets in 5 minutes. Item can be handled in 30 minutes. Full cure in 24 hours. Note: For cooler temperatures, setting time may be longer. To seal syringe, pull back on plunger, wipe tip and place cap firmly on tips (see illustration below). Note: Cap will only fit one way on tips. Store upright with tips up. Cures product withstands: -40° to 176°F (-40° to 80°C). Note: Prolonged exposure to temperature above 85°F may result in pressure build-up in unopened syringe. Use caution when opening, pointing tips away from face and body. Note: Not recommended for drinking water application. Note: When curing product will be visible, pre-check color by mixing small sample on clean card board and viewing final color after 48 hours.
Easy to Use Super Glue in a Precision Applicator! (Cyanoacrylate)
Fingers stay clean!You control the flowSelf piercing capGel works well on porous surfaces & vertical applications A revolutionary precision applicator ...